Installation Procedure
- Install the negative battery cable into the wire loom.
- Connect the negative battery cable (1) to the transaxle stud.
- Install the negative battery cable nut to the transaxle stud.
Tighten: Tighten the nut to 45 N.m (33 lb ft).
- Install the negative battery cable (1) to the inner fender body ground stud.
- Install the negative battery cable body ground nut (2).
Tighten: Tighten the nut to 12 N.m (106 lb in).
- Connect the battery cable retainers (1) to the battery tray.
- Install the battery box. Refer to Battery Box Replacement .
NOTE:
Refer to Fastener Notice
in Cautions and Notices.