LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Solstice Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (Wheel Alignment System) >> Repair Instructions >> Front Camber Adjustment >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the strut to the vehicle. Refer to Strut, Strut Component and/or Spring Replacement .

    Tighten:  Tighten the strut-to-knuckle nuts as far as to allow movement of the knuckle.

    Fig 1: Adjusting Front Camber
    GM156937Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation .
  3. Adjust the camber (1).

    Tighten:  Tighten the strut-to-knuckle nuts to 130 N.m (96 lb ft).

  4. Lower the vehicle.
scientia non olet · About LEMON Manuals