Test Description

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers on the diagnostic table.

2: This test checks to see if any other DTC is set.
3: This test checks to see if steering angle sensor is centered.

DTC C0710

Step	Action	Yes	No
Schematic Reference: ABS Schematics Connector End View Reference: ABS Connector End Views
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Turn OFF the ignition. Install a scan tool. Turn ON the ignition, with the engine OFF. Select the ABS DTC display function. Does the scan tool display any DTC other than DTC C0710?	Go to Diagnostic Trouble Code (DTC) List - Vehicle	Go to Step 3
3	Perform the steering angle sensor centering procedure. Refer to Steering Angle Sensor Centering Procedure . Did you successfully complete the centering procedure?	Go to Step 4	Go to Step 5
4	Use the scan tool in order to clear the DTCs. Test drive the vehicle. Refer to Diagnostic Test Drive . Did DTC C0710 reset?	Go to Step 6	Go to Diagnostic Aids
5	Replace the steering angle sensor. Refer to Steering Wheel Position Sensor or Steering Shaft Lower Bearing Replacement . Did you complete the replacement?	Go to Step 7	-
6	Replace the electronic brake control module (EBCM). Refer to Control Module References for replacement, setup and programming. Did you complete the replacement?	Go to Step 7	-
7	Use the scan tool in order to clear the DTCs. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting test. Does the DTC reset?	Go to Step 2	System OK