LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> GTO Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Anti-Lock Brake System, Traction Control System & Stability Control System) >> Diagnostic Information and Procedures >> DTC C0220-C0229 >> Test Description

Test Description

WARNING: This page is about a different car, the 2007 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

The number below refers to the step number on the diagnostic table.

  1. 2:  Determines whether the DTC is current.
DTC C0220-C0229

Step Action Yes No
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle
2 
  1. Use the scan tool in order to clear the DTCs.
  2. Cycle the ignition to the OFF position.
  3. Start the engine.
  4. In park or neutral, release the brake.
  5. Turn the engine OFF.
Does the DTC reset?		 Go to Step 3  Go to Testing for Intermittent Conditions and Poor Connections
3 Replace the electronic brake control module (EBCM). Refer to Control Module References for replacement, setup, and programming.
Did you complete the replacement?		 Go to Step 4  -
4
  1. Use the scan tool in order to clear the DTCs
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?		 Go to Step 3  System OK
scientia non olet · About LEMON Manuals