LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> GTO Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 6.0L - Introduction (2 Of 2) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing CMP Sensor Mounting Bolt
    GM1554362Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Before installing the camshaft sensor assembly, apply a small amount of clean motor oil to the O-ring (6).
  1. Install the CMP sensor assembly (2, 3) to the engine front cover.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the CMP sensor mounting bolt (1).

    Tighten:  Tighten the camshaft position mounting bolts 25 N.m (18 lb ft).

    3. Fig 2: Disconnecting/Reconnecting Camshaft Position (CMP) Sensor Electrical Connector
    GM1554357Courtesy of GENERAL MOTORS CORP.
  3. Install the CMP sensor electrical connector (1).
  4. Install the generator assembly. Refer to Generator Bracket Replacement in Engine Electrical.
scientia non olet · About LEMON Manuals