LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> G6 GTP, 2D Convertible >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 3.9L - Introduction (2 Of 2) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Electrical Connectors
    GM1582011Courtesy of GENERAL MOTORS CORP.
  1. Install the MAP sensor seal into the upper intake manifold.
  2. Install the MAP sensor.
    3. NOTE: Refer to Fastener Notice .
  3. Install the MAP sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  4. If required, install the spark plug wire clip to the intake manifold bracket.
  5. Connect the MAP sensor electrical connector.
  6. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
scientia non olet · About LEMON Manuals