LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> G6 GT, 2D Convertible >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 3.5L - Introduction (2 Of 2) >> Repair Instructions >> Accelerator Controls Pedal Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing Accelerator Pedal Position Sensor
    GM1544734Courtesy of GENERAL MOTORS CORP.
  1. Install the APP sensor (2).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the APP sensor bolts (1).

    Tighten:  Tighten the accelerator pedal nuts to 10 N.m (89 lb in).

  3. Connect the APP sensor electrical connector.
  4. Confirm that the APP sensor connector locking clip is fully secured.
scientia non olet · About LEMON Manuals