LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Vibe GT >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 1.8L (LNK) - Introduction >> Repair Instructions >> Secondary AIR Injection Pump Replacement >> Removal Procedure

Removal Procedure

  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    2. Fig 1: View Of Secondary Air Injection Pump
    GM1287600Courtesy of GENERAL MOTORS CORP.
  2. The secondary air injection (AIR) pump is located above the inner wheel house and stone shield panel.
    3. Fig 2: View Of Stone Shield, Single Retainer And Bolts
    GM1455354Courtesy of GENERAL MOTORS CORP.
  3. Remove the 2 bolts (2) that secure the stone shield (1).
  4. Remove the single retainer (3) and the stone shield (1).
  5. Swing the stone shield (1) down in order to gain access to the AIR pump assembly.
    6. Fig 3: View Of AIR Pump Components
    GM1287599Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the AIR pump electrical connector (5).
  7. Disconnect the AIR pump relay electrical connector (4).
  8. Disconnect the electrical ground strap (3).
  9. Disconnect the AIR pump discharge hose (6).
  10. Remove the three AIR pump bracket fasteners (1, 2, 7).
  11. Remove the AIR pump assembly from the vehicle.
scientia non olet · About LEMON Manuals