LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Vibe GT >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 1.8L (LNK) - Introduction >> Repair Instructions >> Fuel Pressure Regulator Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Fuel Sender Assembly
    GM1465529Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel sender assembly (2) from the fuel tank. Refer to Fuel Sender Assembly Replacement .
    2. Fig 2: View Of Fuel Sender Assembly Electrical Connectors
    GM1460722Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the fuel pump and fuel level sensor (1) electrical connectors.
    3. Fig 3: View Of Assembly Spring And E-Clip
    GM1460723Courtesy of GENERAL MOTORS CORP.
  3. Compress the assembly spring (1) and remove the E-clip (2) from the guide post of the fuel sender assembly upper support.
    4. Fig 4: View Of Fuel Pump Transfer Jet Tube And Lock Tab
    GM1464192Courtesy of GENERAL MOTORS CORP.
  4. Release the lock tab (1) of the fuel pump transfer jet tube (2) and disconnect the tube from the lower housing.
    5. Fig 5: View Of Fuel Pump And Filter Assembly-To-Lower Housing Lock Tabs
    GM1460724Courtesy of GENERAL MOTORS CORP.
  5. Release the 2 lock tabs (1) securing the fuel pump and filter assembly to the lower housing.
    6. Fig 6: View Of Fuel Pump And Filter Assembly-To-Lower Housing Lock Tabs
    GM1460727Courtesy of GENERAL MOTORS CORP.
  6. Separate the upper support and fuel pump filter assembly (1) from the lower housing (2).
    7. Fig 7: View Of Fuel Pump Strainer Lock Tab
    GM1464195Courtesy of GENERAL MOTORS CORP.
  7. Use a screwdriver with a tape protected end (3) in order to release the 5 lock tabs (1, 2) from the fuel pump strainer assembly.
    8. Fig 8: View Of Fuel Pressure Regulator And Fuel Filter Assembly
    GM1456220Courtesy of GENERAL MOTORS CORP.
  8. Remove the fuel pressure regulator (1) from the fuel filter assembly (2).
scientia non olet · About LEMON Manuals