LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Vibe Base, FWD, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - Mu4 >> Repair Instructions >> Manual Selector Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Manual Selector Nuts
    GM859233Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the manual selector into the vehicle. Secure the manual selector with 4 nuts.

    Tighten:  Tighten the manual selector bolts to 16 N.m (12 lb ft).

    2. Fig 2: Removing/Installing Electrical Connectors
    GM859230Courtesy of GENERAL MOTORS CORP.
  2. Connect the manual selector electrical connectors.
    3. Fig 3: Removing/Installing Shift Select Cable From/To Shift Lever Plate
    GM859224Courtesy of GENERAL MOTORS CORP.
  3. Install the shift select cable into the shift lever plate.
    4. Fig 4: Removing/Installing Shift Select Cable From/To Manual Selector Lever
    GM859221Courtesy of GENERAL MOTORS CORP.
  4. Connect the shift select cable to the manual selector lever.
    5. Fig 5: Disconnecting/Connecting Park Lock Cable From Shift Lever Plate
    GM859218Courtesy of GENERAL MOTORS CORP.
  5. Install the park lock cable to the shift lever plate.
    6. Fig 6: Disconnecting/Connecting Park Lock Cable From Shift Lock Lever
    GM859215Courtesy of GENERAL MOTORS CORP.
  6. Connect the park lock cable to the manual selector lever.
  7. Install the center instrument trim panel. Refer to Trim Panel Replacement - Instrument Panel (I/P) Center in Instrument Panel, Gages and Console.
  8. Install the instrument compartment. Refer to Compartment Replacement - Instrument Panel (I/P) in Instrument Panel, Gages and Console.
  9. Install the front floor console. Refer to Trim Plate Replacement - Front Floor Console in Instrument Panel, Gages and Console.
  10. Connect the negative battery cable.
scientia non olet · About LEMON Manuals