Installation Procedure

NOTE: When removing or installing the backup lamp switch, do not use an open end wrench. Use only a socket in order to avoid damage to the switch assembly.

Fig 1: Locating Backup Light Switch Assembly

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the backup light switch. Using pipe sealant GM P/N 1052080 or equivalent.
Tighten: Tighten the switch to 33 N.m (24 lb ft).

Fig 2: View Of Backup Lamp Connector

Courtesy of GENERAL MOTORS CORP.

Connect the backup lamp connector.