LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Sunfire Automatic >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Inflatable Restraint System >> Repair Instructions >> Inflatable Restraint Side Impact Module Replacement - Front >> Installation Procedure

Installation Procedure

  1. Position the inflator module (1) into the vehicle.
    2. Fig 1: Locating Inflator Module Electrical Connector
    GM834212Courtesy of GENERAL MOTORS CORP.
  2. Connect the electrical connector (2) to the inflator module (1).
  3. Install the CPA (3) to the inflator module electrical connector (2).
    4. Fig 2: View Of Inflator Module
    GM834267Courtesy of GENERAL MOTORS CORP.
  4. Install the inflator module to the seat back frame (2).
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the mounting nuts (1) to the inflator module.

    Tighten:  Tighten the nut to 9 N.m (80 lb in).

  6. Install the seat back cover. Refer to Seat Back Cover Replacement - Front (With AJ7) or Seat Back Cover Replacement - Front (Without AJ7) in Seats.
  7. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 7  or to SIR Disabling and Enabling Zone 9 .
scientia non olet · About LEMON Manuals