LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Sunfire Automatic >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Inflatable Restraint System >> Repair Instructions >> Inflatable Restraint Instrument Panel Module Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Inflatable Restraint I/P Module
    GM202151Courtesy of GENERAL MOTORS CORP.
  1. Install the inflatable restraint module (1) to the I/P
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the mounting bolts (2) to the inflatable restraint module.

    Tighten:  Tighten the bolts to 5 N.m (44 lb in).

    3. Fig 2: Identifying Inflatable Restraint I/P Module Yellow 2-Way Pigtail Connector
    GM202147Courtesy of GENERAL MOTORS CORP.
  3. Connect the yellow 2-way pigtail connector to the inflatable restraint module.
    4. Fig 3: View Of Inflatable Restraint I/P Module Yellow 2-Way Pigtail Connector
    GM202145Courtesy of GENERAL MOTORS CORP.
  4. Install the CPA to the yellow 2-way pigtail connector on the inflatable restraint module.
  5. Install the air distributor duct. Refer to Air Distributor Duct Replacement (Pontiac) in Heating Ventilation and Air Conditioning.
  6. Install the I/P trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) (Pontiac) or Trim Pad Replacement - Instrument Panel (I/P) (Chevrolet) in Instrument Panel, Gages, and Console.
  7. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 5 .
  8. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping .
scientia non olet · About LEMON Manuals