LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Sunfire Automatic >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Inflatable Restraint System >> Repair Instructions >> Inflatable Restraint Front End Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Inflatable Restraint Front End Sensor
    GM202141Courtesy of GENERAL MOTORS CORP.
  1. Install the sensor (1) to the hood latch support bracket (3).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the mounting bolts (2) to the sensor (1).

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  3. Connect the wiring harness connector to the sensor (1).
  4. Install the CPA to the wiring harness connector.
    5. Fig 2: Removing Hood Close Out Panel Push-Pin Retainers
    GM833369Courtesy of GENERAL MOTORS CORP.
  5. Install the hood close out panel to the vehicle.
  6. Install the pushpin retainers to the hood close out panel.
  7. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 1 .
scientia non olet · About LEMON Manuals