LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Grand Prix Base >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle - Introduction & Repair Instructions >> Repair Instructions >> Case Extension Housing Replacement >> Removal Procedure

Removal Procedure

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (RPOs L26/L32) or Battery Negative Cable Disconnect/Connect Procedure (RPO LS4) in Engine Electrical.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Remove the right drive axle from the transaxle. Refer to Wheel Drive Shaft Replacement in Wheel Drive Shafts.
  4. Remove the transaxle brace. Refer to Automatic Transmission Brace Replacement .
  5. Remove the vehicle speed sensor. Refer to Vehicle Speed Sensor (VSS) Replacement .
    6. Fig 1: View Of Case Extension Assembly & Bolts
    GM10517Courtesy of GENERAL MOTORS CORP.
  6. Remove the case extension housing bolts (5).
  7. Remove the case extension housing (6) with the axle seal and the O-ring (8).
    8. Fig 2: Inspecting Case Extension Housing
    GM10606Courtesy of GENERAL MOTORS CORP.
  8. Inspect the case extension (6). Refer to Case Extension Assemble (FWD Only) in Transmission/Transaxle - 4T65E Unit Repair.
scientia non olet · About LEMON Manuals