LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Grand Prix Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 5.3L - Introduction) >> Repair Instructions >> Air Cleaner Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Left Inner Fender Brace
    GM1554558Courtesy of GENERAL MOTORS CORP.
  1. Remove the left inner fender brace. Refer to Brace Replacement - Front Fender Upper Diagonal in Body Front End.
  2. Loosen the air inlet duct clamp at the throttle body.
  3. Remove the air inlet duct from the throttle body.
    4. Fig 2: View Of Positive Crankcase Ventilation (PCV) Clean Air Tube
    GM1551864Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the positive crankcase ventilation (PCV) tube from the air inlet duct. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  5. Disconnect the mass air flow (MAF) sensor electrical connector.
    6. Fig 3: Upper Air Cleaner Housing
    GM1554546Courtesy of GENERAL MOTORS CORP.
  6. Remove the upper air cleaner housing from the lower housing. Disengage the tabs on the upper housing from the slots on the lower housing.
  7. Without disconnecting the powertrain control module (PCM) connectors, remove the PCM and the harness from the lower air cleaner housing.
  8. Without disconnecting the transmission control module (TCM) connectors, remove the TCM and the harness from the lower air cleaner housing.
  9. Loosen the air inlet duct clamp at the air cleaner assembly.
  10. Remove the air inlet duct from the air cleaner.
    11. Fig 4: Lower Air Cleaner Housing
    GM1554550Courtesy of GENERAL MOTORS CORP.
  11. Remove the lower air cleaner housing by pulling the housing from the 2 rubber grommets on the inner rail.
  12. Inspect the air cleaner housing assembly for signs of damage and replace if necessary.
scientia non olet · About LEMON Manuals