LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> GTO Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Engine Controls (Introduction)) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Camshaft Position Sensor Assembly, Jumper Harness & Front Cover
    GM1484001Courtesy of GENERAL MOTORS CORP.
  1. Reconnect the camshaft sensor (5) and the jumper harness (4).
  2. Install the O-ring (6) on the camshaft sensor assembly (4 and 5).
  3. Reconnect the camshaft position sensor assembly (4, 5 and 6) and the engine harness connector (3).
    4. IMPORTANT: Before installing the camshaft sensor assembly, apply a small amount of clean motor oil to the O-ring (6).
  4. Install the camshaft position sensor assembly (4, 5 and 6) in the front cover (7).
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the camshaft position sensor mounting bolts.

    Tighten:  Tighten the camshaft position mounting bolts 25 N.m (18 lb ft).

  6. Install the generator assembly. Refer to Generator Bracket Replacement in Engine Electrical.
scientia non olet · About LEMON Manuals