Deployment Outside Vehicle - Inflatable Restraint Steering Wheel Module
- Turn the ignition switch to the LOCK position.
- Remove the ignition key.
- Put on safety glasses.
- Inspect the J 38826 and the EL-46850 for damage. See Special Tools . Replace as needed.
- Short the 2 SIR deployment harness (1) leads together using one banana plug seated into the other.
- Connect the SIR deployment harness adapter (2) to the SIR deployment harness (1).
- Remove the inflator module from the vehicle.
- Place the module with the vinyl trim cover facing up and away from the surface on a work bench.
- Clear a space on the ground about 1.85 m (6 ft) in diameter for deployment of the module. If possible, use a paved, outdoor location free of activity. Otherwise, use a space free of activity on the shop floor. Make sure you have sufficient ventilation.
- Make sure no loose or flammable objects are in the area.
- Place the module in the space with the vinyl trim cover facing up.
- Extend the SIR deployment harness and adapter to full length from the module.
- Place a 12 volt minimum/2 amp minimum power source, i.e., vehicle battery, near the shorted end of the harness.
- Connect the module (1) to the adapter (2) on the SIR deployment harness (3).
- Firmly seat the adapter into the module connector.
- Clear the area of people.
- Separate the 2 banana plugs on the SIR deployment harness.
- The rapid gas expansion involved with deploying an air bag is very loud. Notify all people in the immediate area that you intend to deploy the inflator module.
- When the air bag deploys, the inflator module may jump about 30 cm (1 ft) vertically. This is a normal reaction of the inflator module to the force of the rapid gas expansion inside the air bag.
- Connect the SIR deployment harness wires to the power source.
- Disconnect the SIR deployment harness from the power source after the air bag deploys.
- Seat one banana plug into the other in order to short the deployment harness leads.
- If the air bag did not deploy, disconnect the adapter and discontinue the procedure. Contact the Technical Assistance Group. Otherwise, proceed to the following steps.
- Put on a pair of shop gloves.
- Disconnect the pigtail adapter from the inflator module as soon as possible.
- Inspect the pigtail adapter and the SIR deployment harness. Replace as needed.
- Dispose of the deployed module through normal refuse channels.
- Wash hands with a mild soap.
CAUTION:
Refer to SIR Inflator Module Handling and Storage Caution
in Cautions and Notices.
CAUTION:
Refer to SIR Inflatable Module Deployment Outside Vehicle Caution
in Cautions and Notices.
IMPORTANT:
CAUTION:
Refer to SIR Deployed Inflator Modules Are Hot Caution
in Cautions and Notices.