LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> GTO Automatic >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Inflatable Restraint System >> Repair Instructions >> Inflatable Restraint Sensing and Diagnostic Module Replacement >> Removal Procedure

Removal Procedure

    CAUTION: Do not strike or jolt the inflatable restraint sensing and diagnostic module (SDM). Before applying power to the SDM, make sure that it is securely fastened with the arrow facing toward the front of the vehicle. Failure to observe the correct installation procedure could cause SIR deployment, personal injury, or unnecessary SIR system repairs.
    CAUTION: If the vehicle interior is exposed to moisture and becomes soaked up to the level of the sensing and diagnostic module (SDM), the SDM and SDM harness connector must be replaced. The SDM could be activated when powered, which could cause airbag deployment and result in personal injury.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 8 .
    2. Fig 1: View Of SDM Assembly
    GM1343048Courtesy of GENERAL MOTORS CORP.
  2. Remove the console in order to access the sensing and diagnostic module (SDM) (1). Refer to Console Replacement - Front Floor in Instrument Panel, Gages and Console.
  3. Remove the SDM electrical connector. Press the locking tab (5) and move the locking lever (4) rearward while removing the connector from the SDM (1).
  4. Remove the three SDM fasteners (2).
  5. Remove the SDM assembly (1) from the vehicle.
scientia non olet · About LEMON Manuals