LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> GTO Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 96 (Supplemental Inflatable Restraint System) >> Repair Instructions >> SIR Disabling and Enabling Zone 2 >> Enabling Procedure

Enabling Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the ignition in the OFF position.
    2. Fig 1: SIS, SIS Connector & CPA
    GM1246629Courtesy of GENERAL MOTORS CORP.
  2. Connect the SIS connector (2) to the SIS (1).
  3. Connect the CPA (3) to the SIS connector (2).
  4. Install the door trim panel. Refer to Trim Panel Replacement - Driver Door in Doors.
    5. Fig 2: Kick-Up Panel, I/P Fuse Block & Cover
    GM1246577Courtesy of GENERAL MOTORS CORP.
  5. Install the SDM fuse into the I/P fuse block.
  6. Install the I/P fuse block cover (1).
  7. Install the kick-up panel (2) to cover the I/P fuse block (1).
  8. Use caution while reaching in and place the ignition to the ON position.

    The AIR BAG indicator will flash then turn OFF.

  9. Perform the Vehicle System Check if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - Vehicle in Vehicle DTC Information.
scientia non olet · About LEMON Manuals