LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> GTO Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (Seat System) >> Repair Instructions >> Seat Back Release Cable Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Release Cables At Upper Seat Back Frame
    GM171524Courtesy of GENERAL MOTORS CORP.
  1. Insert the release cables through the opening in the upper seat back frame.
  2. Snap the release lever mechanism to the seat back frame.
  3. Route the cables.
    4. Fig 2: View Of Seat Hinge Nuts & Bolts
    GM71219Courtesy of GENERAL MOTORS CORP.
  4. Install the release cables to the right and left hinges inserting the locking pins in the notches.
  5. Apply Loctite™ 271 to the hinge bolts.
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the nuts to the right and left hinge bolts.

    Tighten:  Tighten the nuts to 24 N.m (18 lb ft).

  7. Install the free play retention cable to the passenger seat back.
    8. Fig 3: Seat Mounting Component View
    GM71215Courtesy of GENERAL MOTORS CORP.
  8. Install the seat back trim cover and pad. Refer to Seat Back Insert, Pad, Cover Replacement - Front Seat .
scientia non olet · About LEMON Manuals