Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Control Arm & Stabilizer Shaft Link

Courtesy of GENERAL MOTORS CORP.

Install the stabilizer shaft to the vehicle.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the stabilizer shaft insulator clamps to the stabilizer shaft and the crossmember.
Tighten:
- Tighten the stabilizer shaft insulator clamp bolts to 65 N.m (49 lb ft).
- Tighten the stabilizer shaft insulator clamp nuts to 95 N.m (70 lb ft).
Using a back-up wrench to prevent the link stud from rotating, install the stabilizer shaft links to the stabilizer shaft.
Tighten: Tighten the stabilizer shaft link nuts to 72 N.m (53 lb ft).
Install the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
Lower the vehicle.