LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> G6 Base >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - Introduction & Repair Instructions >> Repair Instructions >> Floor Shift Control Replacement >> Removal Procedure

Removal Procedure

    IMPORTANT: All shift cable and park lock cable clips are one time usage only. Any service repair requiring cables to be disconnected from the transaxle control cable bracket or shift assembly will require a cable clip replacement.
  1. Remove the console. Refer to Console Replacement in Instrument Panel, Gages, and Console.
    2. Fig 1: Identifying Shift Cable
    GM1556719Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the shift cable (2) from the control assembly pin.
  3. Remove the shift cable retainer clip and remove the cable (1) from the control assembly. Discard the clip.
    4. Fig 2: Park Lock Cable Assembly
    GM1556721Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the park lock cable assembly (2) from the pin on the control assembly.
  5. Depress the tab on the park lock cable and remove the cable (1) from the control assembly. Discard the park lock cable clip.
    6. Fig 3: Disconnecting Control Assembly Electrical Connectors
    GM944353Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the control assembly electrical connectors.
  7. Set the park brake.
    8. Fig 4: Control Assembly
    GM1556723Courtesy of GENERAL MOTORS CORP.
  8. Remove the nuts from the control assembly.
  9. Remove the control assembly.
scientia non olet · About LEMON Manuals