Installation Procedure

IMPORTANT: Ensure that the adjustable brake pedal and adjustable accelerator pedal are synchronized in the full rearward position.

Insert a #4 square drive tool into the adjustable brake pedal actuator assembly and turn until the adjustable brake pedal assembly moves fully rearward.

Fig 1: Installing 3 Brake Pedal Assembly To Instrument Panel (I/P) Carrier Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the 3 brake pedal assembly to I/P carrier bolts.
Tighten: Tighten the bolts to 25 N.m (18 lb ft).

Fig 2: View Of 2 Brake Pedal Assembly To Cowl Mounting Nuts

Courtesy of GENERAL MOTORS CORP.

Install the 2 brake pedal assembly to cowl mounting nuts.
Tighten: Tighten the nuts to 15 N.m (11 lb ft).

Fig 3: View Of Booster Pushrod Retaining Clip, Washers & Booster Pushrod

Courtesy of GENERAL MOTORS CORP.

Install the booster pushrod retaining clip (1), the washers (2), and the booster pushrod (3) to the adjustable pedal pivot pin (4).
Install the steering column assembly to the vehicle. Refer to Steering Column Replacement in Steering Wheel and Column.
Install the NEW cable. Refer to Adjustable Brake Pedal Cable Replacement .
Install the electrical connector to the brake pedal adjustment position sensor.
Install the electrical connector to the brake apply sensor.
Install the closeout panel. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages, and Console.
Install the knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gages, and Console.
Calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration in Lighting Systems.