Scan Tool Data Definitions
- Battery Voltage Signal
-
The scan tool displays 0.0-16.0 volts. The battery voltage input represents the system voltage measured at the module ignition feed input.
- Windshield Wiper Switch
-
The scan tool displays the set position of the Windshield Wiper Switch.
- Wiper Park Switch
-
The scan tool displays if wipers are in the park position or not. If the scan tool displays Off the wipers are in the parked position.
- Windshield Washer Switch
-
The scan tool displays the position of the wash switch.
- Wiper Motor Delay Time
-
The scan tool displays the Intermittent delay time in seconds. Time periods are between 0-25 seconds.
- Wiper Motor Relay Command
-
The scan tool displays if the BCM is commanding the wiper 1 relay On or Off.
- Wiper Motor Relay Status
-
The scan tool displays the status of the wiper 1 relay.