LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Aztek Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Power Steering System) >> Repair Instructions >> Power Steering Pulley Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT:
    • Never use a hammer to install the power steering pulley.
    • Do not use an arbor press to install the power steering pulley.
    • The face of the pulley hub must be flush with the end of the pump driveshaft.
  1. Using J 25033-C  install the power steering pump pulley to the power steering pump. See Special Tools and Equipment .
  2. Install the power steering pump assembly to the vehicle. Refer to Power Steering Pump Replacement (3.4L)  or Power Steering Pump Replacement (3.8L) .
    3. Fig 1: Installing Power Steering Pump Assembly
    GM293353Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals