LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Aztek Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Engine Control System 3.8L (Introduction)) >> Repair Instructions >> Exhaust Gas Recirculation (EGR) Outlet Pipe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the EGR valve outlet pipe (1).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the EGR outlet pipe bolt (3) to the intake manifold.

    Tighten:  Tighten the bolt to 30 N.m (22 lb ft).

  3. Install the EGR outlet pipe nut (2) to the EGR valve inlet adapter pipe.

    Tighten:  Tighten the nut to 30 N.m (22 lb ft).

  4. Install the air cleaner intake duct. Refer to Air Cleaner Intake Duct Replacement .
    5. Fig 1: Installing EGR Valve Outlet Pipe
    GM703592Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals