LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Aztek Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Wiper System And Washer System) >> Repair Instructions >> Wiper Arm Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the wiper arm onto the wiper transmission.
    2. Fig 1: Wiper Blades & Windshield Blackout
    GM1257436Courtesy of GENERAL MOTORS CORP.
  2. Align the wiper blades to the small voids in the windshield blackout (1 and 2).
  3. Apply Threadlocking compound, GM P/N 89021297 (Canadian P/N 10953488) or equivalent, to the wiper arm nut.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the wiper arm nut.

    Tighten:  Tighten the nut to 30 N.m (22 lb ft).

  5. Install the wiper arm nut cover.
  6. Connect the washer hose to the wiper arm.
  7. Operate the windshield wipers and inspect for proper operation.
  8. Close the hood.
scientia non olet · About LEMON Manuals