LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle - Introduction & Repair Instructions >> Repair Instructions >> Reverse Servo Replacement (LA1) >> Installation Procedure

Installation Procedure

    IMPORTANT: Failure to perform the following step may result in no reverse gear due to the servo pin not aligning with the reverse band.
  1. Raise the driver (left) side of the vehicle until it is higher than the passenger (right) differential side. This ensures that the reverse band is in the proper location.
    2. Fig 1: Identifying Reverse Servo Assembly Components
    GM48173Courtesy of GENERAL MOTORS CORP.
  2. Install the servo spring (49).
  3. Install the servo assembly (42-48).
  4. Install the reverse servo cover (40) with the new O-ring seal (41).
  5. Install the snap ring (39).
  6. Install the throttle body air inlet duct. Refer to Air Cleaner Assembly Replacement in Engine Controls-3.4L.
scientia non olet · About LEMON Manuals