LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle - Introduction & Repair Instructions >> Repair Instructions >> Automatic Transmission Range Selector Cable Replacement >> Removal Procedure

Removal Procedure

  1. Remove the throttle body air inlet duct. Refer to Air Cleaner Intake Duct Replacement in Engine Controls-3.4L.
  2. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls-3.4L.
    3. Fig 1: Locating Automatic Transaxle Range Selector Cable Retaining Clip
    GM161164Courtesy of GENERAL MOTORS CORP.
  3. Use a flat-bladed tool in order to remove the retaining clip from the automatic transaxle range selector cable.
  4. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    5. Fig 2: View Of Automatic Transaxle Range Selector Cable
    GM368792Courtesy of GENERAL MOTORS CORP.
  5. Use a large flat-bladed tool in order to remove the automatic transaxle range selector cable from the cable lever.
  6. Use pliers in order to depress the cable retainers.
  7. Remove the automatic transaxle range selector cable from the automatic transaxle range selector cable bracket.
  8. Lower the vehicle.
  9. Remove the knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gages and Console.
    10. Fig 3: Identifying Transaxle Shift Cable
    GM1236459Courtesy of GENERAL MOTORS CORP.
  10. If the vehicle is equipped with a console shift, perform the following steps:
    1. Remove the console trim plate. Refer to Trim Plate Replacement - Front Floor Console (Aztek) or Trim Plate Replacement - Front Floor Console (Rendezvous) in Instrument Panel, Gages and Console.
    2. Remove the transaxle shift cable from the floor shift control.
    11. Fig 4: View Of Automatic Transaxle Range Selector Cable Retaining Clip
    GM161141Courtesy of GENERAL MOTORS CORP.
  11. If the vehicle is equipped with a column shift, perform the following steps:
    1. Remove the retaining clip from the automatic transaxle range selector cable.
    2. Use a flat-bladed tool in order to remove the automatic transaxle range selector cable from the column control lever.
    3. Remove the automatic transaxle range selector cable from the steering column bracket.
    12. Fig 5: View Of Automatic Transaxle Range Selector Cable In The Cowl
    GM161138Courtesy of GENERAL MOTORS CORP.
  12. Remove the automatic transaxle range selector cable through the cowl.
scientia non olet · About LEMON Manuals