LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> HVAC Systems - Manual >> Repair Instructions >> Mode Actuator Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Locating Mode Actuator Mounting Screws
    GM651491Courtesy of GENERAL MOTORS CORP.
  1. Install the mode actuator.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the mode actuator mounting screws.

    Tighten:  Tighten the screws to 1.6 N.m (14 lb in).

    3. IMPORTANT: Align the counted number of threads on the mode actuator push rod (2) with the tip of the retainer clip (1).
    Fig 2: Identifying Push Rod Retainer Clip
    GM828359Courtesy of GENERAL MOTORS CORP.
  3. Connect the mode actuator push rod (2) to the retainer clip (1).
  4. Close the push rod retainer clip (1).
  5. Connect the mode actuator electrical connector.
  6. Connect the I/P wiring harness clip to the I/P support bracket.
  7. Install the knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gages and Console.
  8. Recalibrate the actuators. Refer to Re-Calibrating Actuators .
scientia non olet · About LEMON Manuals