LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 94 (Engine Controls (Introduction) - 3.8L) >> Repair Instructions >> Air Cleaner Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the air cleaner housing by pushing the housing (1) into the 2 rubber grommets (2) in the engine compartment.
    2. Fig 1: View Of Air Cleaner Housing
    GM444479Courtesy of GENERAL MOTORS CORP.
  2. Install the PCM and the harness into the air cleaner housing (3).
    3. Fig 2: View Of Air Cleaner Housing, Bolts, PCM & Harness
    GM444496Courtesy of GENERAL MOTORS CORP.
  3. Install the air cleaner housing cover assembly (1).
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the air cleaner housing screws (2).

    Tighten:  Tighten the screws to 3 N.m (27 lb in).

  5. Install the air cleaner intake duct. Refer to Air Cleaner Intake Duct Replacement .
  6. Install the left inner fender brace. Refer to Brace Replacement - Front Fender Upper Diagonal in Body Front End.
scientia non olet · About LEMON Manuals