LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Engine Control System 3.8L (Introduction)) >> Repair Instructions >> Throttle Position (TP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the fuel injector sight shield. Refer toFuel Injector Sight Shield Replacement in Engine Mechanical-3.8L.
  2. Disconnect the throttle position (TP) sensor electrical connector.
    3. Fig 1: Disconnecting TP Sensor Electrical Connector
    GM178680Courtesy of GENERAL MOTORS CORP.
  3. Remove the 2 TP sensor screws.
    4. Fig 2: Removing TP Sensor Screws
    GM178693Courtesy of GENERAL MOTORS CORP.
  4. Remove the TP sensor.
    5. Fig 3: Removing TP Sensor
    GM178694Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals