LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Engine Control System 3.8L (Introduction)) >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the CKP sensor to the block.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the CKP sensor bolts.

    Tighten:  Tighten the bolts to 30 N.m (22 lb ft).

    3. Fig 1: Installing CKP Sensor
    GM12303Courtesy of GENERAL MOTORS CORP.
  3. Install the CKP sensor shield (1).
    4. Fig 2: Installing CKP Sensor Shield
    GM12302Courtesy of GENERAL MOTORS CORP.
  4. Connect the CKP sensor electrical connector.
  5. Install the crankshaft balancer. Refer to Crankshaft Balancer Replacement in Engine Mechanical-3.8L.
  6. Install the right splash shield cover. Refer to Splash Shield Replacement - Engine - Right in Body Front End.
  7. Lower the vehicle.
  8. Connect the negative battery cable.
  9. Perform the Crankshaft Variation Learn Procedure. Refer to CKP System Variation Learn Procedure .
scientia non olet · About LEMON Manuals