LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Engine Control System 3.4L (Introduction)) >> Repair Instructions >> Throttle Position (TP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the fuel lines. Refer to Quick Connect Fitting(s) Service (Metal Collar) .
  2. Disconnect the throttle position (TP) sensor electrical connector.
    3. Fig 1: View Of TP Sensor & Electrical Connector
    GM69065Courtesy of GENERAL MOTORS CORP.
  3. Remove the TP sensor screws.
    4. Fig 2: Removing TP Sensor Screws
    GM201482Courtesy of GENERAL MOTORS CORP.
  4. Remove the TP sensor and the O-ring.
    5. Fig 3: Removing TP Sensor
    GM201473Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals