LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Engine Control System 3.4L (Introduction)) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the MAP sensor to the bracket.
  2. Install the inlet vacuum hose to the MAP sensor.
  3. Connect the MAP sensor electrical connector.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the MAP sensor screws.

    Tighten:  Tighten the screws to 3 N.m (27 lb in).

    5. Fig 1: Removing MAP Sensor
    GM54360Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals