Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
- Install the BPMV and EBCM assembly (2) to the BPMV mounting bracket (4).
- Install the BPMV bracket (4) to the strut tower.
- Install the 1 bolt and 3 nuts that attach the BPMV mounting bracket (4) to the strut tower.
Tighten:
- Tighten the lower 2 BPMV mounting bracket nuts (3) and bolt to 10 N.m (89 lb in).
- Tighten the top nut (1) for BPMV mounting bracket (4) to strut tower to 3 N.m (27 lb in).
- Reconnect the ground strap between the EBCM assembly and the chassis.
- Turn the ignition switch to the RUN position, engine off.
- Perform the Diagnostic System Check - ABS .
NOTE:
Refer to Fastener Notice in Cautions and Notices.