LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Engine Controls - 3.6L - Introduction) >> Repair Instructions >> Accelerator Pedal Position (APP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition OFF.
  2. Remove the closeout/insulator panel from under the dashboard on the drivers side. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages, and Console.
    3. Fig 1: View Of Accelerator Pedal Components
    GM1404029Courtesy of GENERAL MOTORS CORP.
    NOTE: Handle the electronic throttle control components carefully. Use cleanliness in order to prevent damage. Do not drop the electronic throttle control components. Do not roughly handle the electronic throttle control components. Do not immerse the electronic throttle control components in cleaning solvents of any type.
  3. Disconnect the accelerator pedal position (APP) sensor electrical connector from the accelerator pedal module.
  4. Remove the APP sensor mounting bolts.
  5. Remove the APP sensor from the vehicle.
scientia non olet · About LEMON Manuals