LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 109 (Body Front End) >> Repair Instructions >> Hood Latch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the hood latch release cable to the hood latch.
    2. Fig 1: View Of Hood Latch Release Cable
    GM363788Courtesy of GENERAL MOTORS CORP.
  2. Position the hood latch to the marks on the hood latch support bracket.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the hood latch to center support bracket bolts.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

    4. Fig 2: View Of Hood Latch & Bolts
    GM363798Courtesy of GENERAL MOTORS CORP.
  4. Adjust the hood as required. Refer to Hood Adjustment .
  5. Position the hood latch closeout panel to the vehicle.
    6. Fig 3: View Of Hood Latch Closeout Panel
    GM1228692Courtesy of GENERAL MOTORS CORP.
  6. Install the push-in retainers (1) to the hood latch closeout panel.
    7. Fig 4: View Of Hood Latch Closeout Panel Push-In Retainers
    GM1228690Courtesy of GENERAL MOTORS CORP.
  7. Close the hood.
scientia non olet · About LEMON Manuals