LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 109 (Body Front End) >> Repair Instructions >> Hood Air Extractor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the body panel using Varnish Makers and Painters (VMP) naphtha.
  2. Using a small paint brush apply zinc-chromate primer to the spoiler stud inner and outer holes.
  3. Clean the hood attachment surface using with isopropyl alcohol and allow to flash off for 30 seconds.
    4. IMPORTANT: Do not touch the adhesive backing.
  4. Remove the backing tape from the underside of the heat extractor
  5. Install the hood air extractor to the hood, pressing into place until the adhesive is fully seated
    6. Fig 1: View Of Hood Air Extractor
    GM630904Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the new nuts (mastic washers) to the studs on the hood air extractors.

    Tighten:  Tighten the hood air extractor nuts to 2 N.m (18 lb in).

    7. Fig 2: View Of Hood Air Extractor Nuts
    GM630905Courtesy of GENERAL MOTORS CORP.
  7. Close the hood.
scientia non olet · About LEMON Manuals