LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Repair Instructions >> Cruise Release Switch Replacement >> Installation Procedure

Installation Procedure

  1. Install the cruise control release switch electrical connector.
    2. Fig 1: Identifying Cruise Control Release Switch
    GM882912Courtesy of GENERAL MOTORS CORP.

  2. With the electrical connector index notch at the 10 o'clock position, install the cruise control release switch to the retainer.

    3. IMPORTANT: Do NOT move or push the brake pedal.
  3. Slide the switch into the retainer until the plunger is fully depressed into the barrel.
    4. Fig 2: Aligning Cruise Release Switch Until Travel Stop Is Reached
    GM882916Courtesy of GENERAL MOTORS CORP.
  4. Rotate the cruise control release switch clockwise until the travel stop has been reached (approximately 60 degrees). The electrical connector index notch should now be at the 12 o'clock position.
  5. Ensure that the cruise control system operates properly.
  6. Install the left side instrument panel insulator. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages and Console.
scientia non olet · About LEMON Manuals