LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Vibe Base, FWD, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - Mu4 (Introduction, Service & Replacement) >> Repair Instructions >> Vehicle Speed Sensor (VSS) Replacement >> Installation Procedure

Installation Procedure

  1. Apply J 36850  to the VSS O-ring.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the Vehicle Speed Sensor (VSS) into the transaxle case. Secure the VSS (2) with the retaining bolt (1).

    Tighten:  Tighten the VSS speed sensor (VSS) bolt to 6 N.m (53 lb in).

    3. Fig 1: Retaining Bolt And Vehicle Speed Sensor
    GM428221Courtesy of GENERAL MOTORS CORP.
  3. Connect the VSS electrical connector.
  4. Connect the negative (-) battery cable.
scientia non olet · About LEMON Manuals