LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Vibe Base, FWD, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (Introduction) - 1.8L (LV6) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement (AWD) >> Installation Procedure

Installation Procedure

    Fig 1: FTP Sensor And Retaining Clip (AWD)
    GM828936Courtesy of GENERAL MOTORS CORP.
  1. Install the FTP sensor (1) to the fuel sender assembly.
  2. Install the retaining clip (2) to the FTP sensor.
    3. Fig 2: (FTP) Sensor And Fuel Sender Electrical Connector (AWD)
    GM828353Courtesy of GENERAL MOTORS CORP.
  3. Connect the fuel sender electrical connector (2).
  4. Connect the FTP sensor electrical connector (1).
  5. Inspect the butyl caulk seal for the fuel sender access panel (1). Replace any missing butyl caulk as necessary.
  6. Install the access panel to the rear seat floor.
  7. Relocate the carpet under the seat and the left sill plate area.
  8. Install the sill plate to the left side door opening.
  9. Install the rear seat bottom cushion.
  10. Secure the seat cushion with the two fasteners. Refer to Seat Cushion Replacement - Rear in Seats.
scientia non olet · About LEMON Manuals