LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Vibe Base, FWD, Automatic >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Battery Positive Cable Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Grounding Nuts, Bolts, And Battery Cables
    GM830260Courtesy of GENERAL MOTORS CORP.
  1. Position the positive (+) battery cable (4) into the vehicle.
  2. Route the positive (+) cable into the harness loom.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Connect the cable to the starter solenoid. Secure the cable with the retaining nut.

    Tighten:  Tighten the positive (+) battery cable-to-starter solenoid retaining nut to 9 N.m (78 lb in).

  4. Install the battery positive fuse block feed cable to positive (+) battery cable. Secure with the nut (5).

    Tighten:  Tighten the positive (+) battery cable-to- relay block 1 feed cable retaining nut to 9 N.m (78 lb in).

  5. Tape the loom to prevent dirt and moisture from entering the harness.
  6. Install the positive (+) battery cable harness loom to the harness retainers.
  7. Install the plastic insulator to the positive (+) battery cable.
  8. Install the battery to the vehicle. Refer to Battery Replacement .
scientia non olet · About LEMON Manuals