LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Vibe Base, AWD >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Power Steering Pump Flow Control Valve Replacement - On Vehicle >> Installation Procedure

Installation Procedure

    NOTE: Refer to Using Proper Power Steering Fluid Notice in Cautions and Notices.
  1. Apply fluid to the spring. Refer to Fluid and Lubricant Recommendations Maintenance and Lubrication.
  2. Install the spring to the pump.
  3. Apply fluid to the flow control valve.
  4. Install the flow control valve to the pump.
  5. Apply fluid to the gasket.
  6. Install the gasket to the union.
    7. NOTE: Refer to Fastener Notice in Cautions and Notices.
  7. Install the union to the pump.

    Tighten:  Tighten the union to 69 N.m (50.9 lb ft).

    8. Fig 1: Power Steering Pump Components
    GM820256Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Installing Hoses without Twists or Bends Notice in Cautions and Notices.
  8. Install the outlet pipe fitting (1) to the pump.

    Tighten:  Tighten the fitting to 41 N.m (30.2 lb ft).

  9. Install the outlet pipe clamp bolt (2).

    Tighten:  Tighten the bolt to 7.8 N.m (69.04 lb in).

  10. Install the right front tire and wheel assembly to the vehicle. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  11. Lower the vehicle.
  12. Fill the reservoir. Refer to Checking and Adding Power Steering Fluid .
  13. Inspect the power steering system for leaks. Repair as necessary.
  14. Install the right front engine splash shield. Refer to Splash Shield Replacement - Engine - Right in Body Front End.
    15. NOTE: Refer to Air in the Power Steering System Notice in Cautions and Notices.
  15. Bleed the power steering system. Refer to Bleeding the Power Steering System .
scientia non olet · About LEMON Manuals