Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.

Install the front wheel speed sensor to the steering knuckle.

Fig 1: View Of Front Wheel Speed Sensor
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.
Install the front wheel speed sensor retaining bolt.
Tighten: Tighten the bolt to 12 N.m (107 lb in).
Connect the electrical connector to the front wheel speed sensor.

Fig 2: View Of Front Wheel Speed Sensor Electrical Connector
Courtesy of GENERAL MOTORS CORP.
Lower the vehicle.
Perform the Diagnostic System Check - ABS .