LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 121 (Antilock Brake System, Traction Control System & Stability Control System) >> Repair Instructions >> Steering Wheel Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to SIR Caution in Cautions and Notices.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 .
  2. Place the front wheels in the straight ahead position.
  3. Remove the steering wheel from the steering column. Refer to Steering Wheel Replacement in Steering Wheel and Column.
    4. Fig 1: Identifying Upper Steering Column Components
    GM820027Courtesy of GENERAL MOTORS CORP.
  4. Remove the 3 screws and the steering column lower trim cover (6) from the steering column.
    5. Fig 2: Steering Wheel Module Coil Electrical Connector Location
    GM839654Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the steering wheel module coil electrical connector.
  6. Disconnect the steering wheel position sensor electrical connector.
    7. Fig 3: Steering Wheel Module Coil, Steering Column And Claws
    GM820030Courtesy of GENERAL MOTORS CORP.
  7. Slide the steering column upper cover, release the 3 claws (2) and remove the steering wheel module coil (1).
  8. Remove the steering wheel position sensor from the steering wheel module coil.
scientia non olet · About LEMON Manuals