LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Sunfire Standard >> Repair and Diagnosis >> Steering >> Manual Steering >> Power Steering System >> Repair Instructions >> Power Steering Pump Flow Control Valve Replacement - Off Vehicle >> Assembly Procedure

Assembly Procedure

  1. Install the flow control spring (2) to the hydraulic pump housing assembly (1).
  2. Install the control valve assembly (3).
  3. Lubricate the new O-ring seal (4) with power steering fluid.
    Fig 1: Exploded View Of Power Steering Pump
    GM428353Courtesy of GENERAL MOTORS CORP.
  4. Install the O-ring seal (4) on to the O-ring union fitting (5).
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the O-ring union fitting (5) into the hydraulic pump housing assembly (1).

    Tighten:  Tighten the O-ring union fitting to 75 N.m (55 lb ft).

scientia non olet · About LEMON Manuals