LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Sunfire Standard >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat System >> Repair Instructions >> Seat Replacement >> Installation Procedure

Installation Procedure

  1. Install the seat to the vehicle.
  2. Connect the wire harness for the SIAB, if equipped.
  3. Connect the seat belt wire harness on the driver's side.
  4. Position the seat fully forward to gain access to the seat adjuster rear nuts (3).
  5. Install the front bucket seat rear adjuster nuts (3).

    Hand tighten the nuts.

    Fig 1: Installing Seat Adjuster Stud Nuts
    GM605613Courtesy of GENERAL MOTORS CORP.
  6. Adjust the seat fully rearward.
  7. Verify both lock bars are engaged in the most forward adjustment in the same notch on both of the seat adjusters.
    8. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  8. Install the front bucket seat front adjuster nuts (3).

    Tighten:  Tighten the nuts to 28 N.m (21 lb ft).

  9. Adjust the front bucket seat to the full forward position and tighten the rear adjuster nuts.

    Tighten:  Tighten the nuts to 28 N.m (21 lb ft).

  10. Install the seat adjuster stud covers (2).
  11. Enable the SIR system, if equipped with SIAB. Refer to SIR Disabling and Enabling Zone 7 or SIR Disabling and Enabling Zone 9 in SIR.
scientia non olet · About LEMON Manuals