LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> GTO Automatic >> Repair and Diagnosis >> Brakes >> Antilock Brake System And Traction Control System >> Repair Instructions >> Brake Pressure Modulator Valve (BPMV) Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Brake Module Assembly, EBCM Harness Connector, Bracket & Nuts
    GM1310267Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the brake pressure modulator assembly (2) to the bracket (3). Secure with 2 nuts (1).

    Tighten:  Tighten the brake modulator assembly nuts to 8.5 N.m (75 lb in).

  2. Remove the plugs from brake pipes and connect the brake pipes to the brake modulator assembly (2).

    Tighten:  Tighten the brake pipe fittings nuts to 9.5 N.m (84 lb in).

  3. Connect the EBCM electrical connector (4).
  4. Bleed the brake system. Refer to Hydraulic Brake System Bleeding in Hydraulic Brakes.
  5. Perform Diagnostic System Check - ABS .
scientia non olet · About LEMON Manuals